Installation on Red Hat (.rpm)
Before installing, we recommend you to read the main installation page.
Basic Installation
In this section, you can read how to set up SoulFire on your Red Hat PC.
Download the software
Download the latest Red Hat installer from the front page.
Run the installer
To run the installer, open a terminal and navigate to the directory where you downloaded the installer. Then, run the following command:
sudo dnf install [filename].rpmLet the installer do its work
The installer will now install SoulFire on your system. This should only take a few seconds.
That’s it!
You should now have SoulFire installed on your Red Hat PC. You can now start using it.
Next steps
After installing SoulFire, you can read the GUI Mode Guide to learn how to use the software.